Category Archives: Meinberg

Meinberg LTOS: “syslog-ng” and the Observed Implementation Pitfalls

Meinberg, with the great help of Mr Weber, has implemented “syslog over TLS” in the LTOS version 7.06. The following report describes the general advantages of “syslog over TLS” and the implementation of it in the LTOS.

Continue reading Meinberg LTOS: “syslog-ng” and the Observed Implementation Pitfalls

Monitoring a Meinberg LANTIME NTP Server

Monitoring a Meinberg LANTIME appliance is much easier than monitoring DIY NTP servers. Why? Because you can use the provided enterprise MIB and load it into your SNMP-based monitoring system. Great. The MIB serves many OIDs such as the firmware version, reference clock state, offset, client requests, and even more specific ones such as “correlation” and “field strength” in case of my phase-modulated DCF77 receiver (which is called “PZF” by Meinberg). And since the LANTIME is built upon Linux, you can use the well-known system and interfaces MIBs as well for basic coverage. Let’s dig into it:

Continue reading Monitoring a Meinberg LANTIME NTP Server

Meinberg LANTIME NTP Authentication

Operating NTP in a secure manner requires the usage of NTP authentication, refer to my Why should I run own NTP Servers? blogpost. Using the Meinberg LANTIME NTP appliance with NTP authentication is quite simply since it requires just a few clicks. Even adding more and more keys (which requires manual work on any other Linux ntp installation) is done within clicks. That’s the way it should be.

Continue reading Meinberg LANTIME NTP Authentication

NTP Appliance: Meinberg LANTIME & SyncFire

In case you’re responsible for an enterprise network or data center you should care about NTP. Refer to “Why should I run own NTP Servers?“. As a hobby technician you might first think about Raspberry Pis with self soldered GPS modules. Well, good idea to play with, but not reliable at all. Way to unstable, hard to update, no alerting, no service agreements, and so on.

Hence you should use a dedicated NTP appliance such as the Meinberg LANTIME NTP Time Servers. I am using a LANTIME M200 with a DCF77 correlation receiver in my lab. With this post I am showing how to set up this NTP server, giving some insights, and listing the advantages of such an appliance compared to a Raspberry Pi or any other DIY server approach. My wish list aka feature requests to this product round things up.

Continue reading NTP Appliance: Meinberg LANTIME & SyncFire